Emoncms stopped saving feeds

i wanted to keep my other thread as clean as possible so here it goes

 

i have discovered that Emoncms stopped recording the feeds...

 

tried to delete them and create them again but no luck...

 

only for very short this morning after i had left the pi off could i get it to record for a few mins and now back to it does not...

 

what can cause this? reboots does not help it... inputs are fine and so are the feeds values...

 

only it will not save them to disk

boelle's picture

Re: Emoncms stopped saving feeds

now a bit later it has saved the 2 feeds... 

 

could it be that it does not save at 1 min interval as it should?

TrystanLea's picture

Re: Emoncms stopped saving feeds

How often is it saving for you? It should be every 1 minute, how often is your data coming in?

boelle's picture

Re: Emoncms stopped saving feeds

have not noted how often it saves.... data comes every 5 sec from node

boelle's picture

Re: Emoncms stopped saving feeds

came to mind that the problem was that it stopped saving, even if i deleted the feeds and created them again... not even reboot helped... and last time it must have taken at least 30 mins before it worked... 

 

what could prevent it from saving?

 

and is there an easy way to clear all what is saved without the need to delete the feeds? i plan to wipe saved data once i get the water meter on the system too...

boelle's picture

Re: Emoncms stopped saving feeds

i  created a -input to try and log the difference between the feed value and the value at the last reading to get the diff between readings...

 

that did not work and it stopped updating all inputs and also the feeds

 

i had to clear some of the inputs to get it going again

 

i then cleared all the feeds and created them again to start fresh...

 

now it does not save the feeds again and i wait more than 5 mins....

 

what makes it stop saving? and when it starts to save is there a command that can clear the datapoints so i can clear out old test data without touching the setup as such?

boelle's picture

Re: Emoncms stopped saving feeds

it seems that a reboot and click on refresh feed size does teh trick... not sure thou

boelle's picture

Re: Emoncms stopped saving feeds

funny thing...

http://energymonitor-dk.dns4e.net/emoncms/boelle/heat

 

if you look at the graphs and click daily they now show data before i created the feeds.... how can that be?

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.