Home » Forums » Archived: Questions and support

Help Troubleshooting nanode RF

Submitted by dkeach on Wed, 21/05/2014 - 20:02

I've been having problems with my nanode RF for a while now.  The red led will intermittently turn on, stay on and no data is transmitted until I reset the board.  I cannot get it to happen when I monitor serial communication with my laptop.  I am running the multinode firmware.

How else could I troubleshoot the issue without connecting to the laptop?  It has to be a communication issue between the nanode RF and my router as there are no RF_Fails being sent to emoncms.org.  Any advice would be greatly appreciated.

‹ Disconnecting emonTx V3 from CTs and safety Problem getting sensors to work ›
»
Robert Wall's picture

Re: Help Troubleshooting nanode RF

Submitted by Robert Wall on Wed, 21/05/2014 - 23:05.

My thoughts tend towards two possible areas to look at. DHCP lease? or are you using static IP addresses? Is it a serial comms problem? - can you remove all the serial comms output once you're past the initial set-up (or wrap it all in #ifdefs)?

»
dkeach's picture

Re: Help Troubleshooting nanode RF

Submitted by dkeach on Thu, 22/05/2014 - 01:39.

I'll stop the comms and see what happens.  I'm on a DHCP lease, not static.  

»

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.