Archived Forum

HI I have been watching this site and forums for a while and decided to dive in so I have built the emontx, emonglcd and am currently setting up the nanoderf.

However I am having some trouble with the nanode rf, I am using the Nanoderf multinode sketch with the sketch uploaded and the serial monitor open I receive the following information.

[webClient]
DHCP status: 1
IP:  10.0.0.65
GW:  10.0.0.138
DNS: 8.8.8.8
DNS status: 1
SRV: 213.138.101.177
Data sent: /api/post.json?apikey=3bf15cf165eabdb9cebba689d27568d9&json={rf_fail:1}
Time request sent
Data sent: /api/post.json?apikey=3bf15cf165eabdb9cebba689d27568d9&node=10&csv=0,1,-12700,-12700,-12700,-12700
Data sent: /api/post.json?apikey=3bf15cf165eabdb9cebba689d27568d9&node=20&csv=2250
Data sent: /api/post.json?apikey=3bf15cf165eabdb9cebba689d27568d9&node=20&csv=2250
Data sent: /api/post.json?apikey=3bf15cf165eabdb9cebba689d27568d9&node=10&csv=0,1,-12700,-12700,-12700,-12700
Data sent: /api/post.json?apikey=3bf15cf165eabdb9cebba689d27568d9&node=20&csv=2250
Data sent: /api/post.json?apikey=3bf15cf165eabdb9cebba689d27568d9&node=10&csv=0,1,-12700,-12700,-12700,-12700
Data sent: /api/post.json?apikey=3bf15cf165eabdb9cebba689d27568d9&node=20&csv=2250
Data sent: /api/post.json?apikey=3bf15cf165eabdb9cebba689d27568d9&node=10&csv=0,1,-12700,-12700,-12700,-12700
Data sent: /api/post.json?apikey=3bf15cf165eabdb9cebba689d27568d9&node=20&csv=2250

As far as I can see;

•  DHCP is ok as I have an IP address.
• I am receiving data from both the emontx and emonglcd.
• I am not getting a response from the server for both the time request and data. ??

So any help would be greatly appreciated as the problem may be completely obvious to someone else or to at least point me in the right direction

Thanks Paul

Update after some searching and a few examples nanoderf sketches was able to post to emoncms :)  

needless to say all sorted, for any Australians reading this sometimes two heads aren't better than one :0 

can explaim if you need to.