Home » Forums » Archived: Questions and support

CT / Power(4) input not working

Submitted by torgeir on Sun, 20/12/2015 - 09:31

I can't get any reading from my power4 input, just tried to connect my last CT to it (the other 3 works).

Also tried connecting the CT -1 to the power4 input but still 0 reading.

Is there some configuration needed to enable it or could the input be "dead" ? Is there any other way to debug this?
 

‹ Hardware To Buy for simple Web connected Energy monitor New installation IT-network 3Phase ? ›
»
calypso_rae's picture

Re: CT / Power(4) input not working

Submitted by calypso_rae on Sun, 20/12/2015 - 09:53.

For the standard emonTx V3 software, the presence or absence of each CT is determined at start-up.   If you re-start the processor with all the CT's in place, maybe they will all work as expected.
 

»
torgeir's picture

Re: CT / Power(4) input not working

Submitted by torgeir on Sun, 20/12/2015 - 11:54.

Oh, that simple...embarrassing I didn't even try that. Thank you! ;-)

»

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.